Hi
I am totally new at Linux so I can use any help available. I am trying to burn a music CD with K3b on Knoppix and it just is not happening. I have used the GUI and the root command to open K3b and everything is fine until I start burning. At this point it says the wodim can't open the cd Burner. HELP!!!
Here is the command line response:
System
-----------------------
K3b Version: 1.0.5
KDE Version: 3.5.10
QT Version: 3.3.8b
Kernel: 2.6.28.4
Devices
-----------------------
CD-ROM CCD-52X6D YSQ4 (/dev/hdd, ) [CD-ROM] [CD-ROM] [None]
LITE-ON DVDRW SOHW-1633S BS0Y (/dev/hdc, ) [CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD+R, DVD+RW, DVD+R DL] [DVD-ROM, DVD-R Sequential, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite]
Used versions
-----------------------
cdrecord: 1.1.9
cdrecord
-----------------------
/usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/hdc'
devname: '/dev/hdc'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.9
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 0 = CD-DA
Driveropts: 'burnfree'
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'LITE-ON '
Identification : 'DVDRW SOHW-1633S'
Revision : 'BS0Y'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE FORCESPEED
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1895168 = 1850 KB
FIFO size : 12582912 = 12288 KB
Speed set to 2822 KB/s
pregap1: -1
Track 01: audio 30 MB (03:02.32) no preemp swab copy
Track 02: audio 34 MB (03:27.29) no preemp swab copy
Track 03: audio 34 MB (03:25.72) no preemp swab copy
Track 04: audio 28 MB (02:49.2 no preemp swab copy
Track 05: audio 31 MB (03:07.25) no preemp swab copy
Track 06: audio 11 MB (01:06.46) no preemp swab copy
Track 07: audio 12 MB (01:13.46) no preemp swab copy
Total size: 183 MB (18:11.80) = 81885 sectors
Lout start: 184 MB (18:13/60) = 81885 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, high Beta category (A+) (3)
ATIP start of lead in: -11634 (97:26/66)
ATIP start of lead out: 359846 (79:59/71)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 277961
Forcespeed is OFF.
Starting to write CD/DVD at speed 16.0 in real SAO mode for single session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Sending CUE sheet...
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 0 of 30 MB written.
Errno: 0 (Success), write_g1 scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 08 03 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x08 Qual 0x03 (logical unit communication crc error (ultra-dma/32)) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63504
cmd finished after 0.200s timeout 200s
/usr/bin/wodim: A write error occured.
/usr/bin/wodim: Please properly read the error message above.
write track data: error after 0 bytes
Writing time: 16.801s
Average write speed 175.7x.
Fixating...
Fixating time: 21.088s
/usr/bin/wodim: fifo had 192 puts and 1 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%.
BURN-Free was never needed.
cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/hdc speed=16 -dao driveropts=burnfree -eject -useinfo -audio /tmp/kde-knoppix/k3b_audio_0_01.inf /tmp/kde-knoppix/k3b_audio_0_02.inf /tmp/kde-knoppix/k3b_audio_0_03.inf /tmp/kde-knoppix/k3b_audio_0_04.inf /tmp/kde-knoppix/k3b_audio_0_05.inf /tmp/kde-knoppix/k3b_audio_0_06.inf /tmp/kde-knoppix/k3b_audio_0_07.inf
Have mercy on a newbie. I have just arrived from years of that "Other OS" and have not use the command line is years..
Ken
AMD EPYC 7282 CPU Processor 16 Cores 32 Threads 2.8GHZ up to 3.2GHZ 120W no lock
$76.00
Intel - Core i7-12700K Desktop Processor 12 (8P+4E) Cores up to 5.0 GHz Unloc...
$419.99
AMD Ryzen 9 5950X 16-core 32-thread Desktop Processor
$319.99
Intel - Core i9-12900K Desktop Processor 16 (8P+8E) Cores up to 5.2 GHz Unloc...
$619.99
Intel Core i5-6500 3.2GHz 6MB SR2L6 / SR2BX Skt. FCLGA1151 Desktop Processor CPU
$24.50
Intel Xeon E5-2697A V4 2.6GHz CPU Processor 16-Core Socket LGA2011 SR2K1
$39.99
Intel Core i7-14700K Unlocked Desktop Processor
$409.99
Intel Quad Core i3-12100 3.3GHz 12MB LGA1700 12th Gen. CPU Processor SRL62
$46.08
Intel Core i7-3770 3.40GHz 8MB Quad Core Socket LGA1155 CPU Processor SR0PK
$35.00
Intel 16 Core i7-13700T DESKTOP processor TURBO Boost 4.90Ghz CM8071504820903
$269.00