-
Junior Member
registered user
Network works on 5.1.1 but not on 5.3.1
Hello,
Need some advice how to solve this problem. The network works on 5.1.1 but does not on 5.3.1
I am using old an IBM Thinkpad with PCMCIA LAN and PCMCIA Wireless adapters. Both work fine on Windows XP. and Knoppix 5.1.1 (need ndiswrapper for wireless). In 5.1.1 the LAN connects right away after boot up. Wireless connects right away after "ifconfig wlan0 up". Never need to "pump -i ...". The IP assigned by the router.
Both wired and wireless don't work on 5.3.1.
For LAN
The LAN card was detected and lsmod shows 8139too correctly, same as 5.1.1, but the network is not connected.
- ifconfig did not show eth0. I did "ifconfig eth0 up", then it appear
Code:
root@Knoppix:/ramdisk/home/knoppix# ifconfig
eth0 Link encap:Ethernet HWaddr 00:10:d7:09:9d:ca
inet6 addr: fe80::210:d7ff:fe09:9dca/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:10 Base address:0x8000
- Still not connected, so I did "pump -i eth0", wait for a while then "Operation failed". The dmesg shows
Code:
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
eth0: no IPv6 routers present
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timeout, status 0d 0004 c07f media 00.
eth0: Tx queue start entry 4 dirty entry 0.
eth0: Tx descriptor 0 is 0008a05a. (queue head)
eth0: Tx descriptor 1 is 0008a04e.
eth0: Tx descriptor 2 is 0008a046.
eth0: Tx descriptor 3 is 0008a05a.
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timeout, status 0c 0005 c07f media 00.
eth0: Tx queue start entry 4 dirty entry 0.
eth0: Tx descriptor 0 is 0008a046. (queue head)
eth0: Tx descriptor 1 is 0008a046.
eth0: Tx descriptor 2 is 0008a156.
eth0: Tx descriptor 3 is 0008a156.
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
eth0: no IPv6 routers present
NETDEV WATCHDOG: eth0: transmit timed out
For wireless
- After I have loaded ndiswrapper, the light on the card blinked normally. ifconfig wlan0 up was successful.
Code:
root@Knoppix:/ramdisk/home/knoppix# ifconfig
eth0 Link encap:Ethernet HWaddr 00:10:d7:09:9d:ca
inet6 addr: fe80::210:d7ff:fe09:9dca/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:10 Base address:0x8000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:100 (100.0 B) TX bytes:100 (100.0 B)
wlan0 Link encap:Ethernet HWaddr 00:15:e9:6c:3e:c7
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:11 Memory:24000000-24020000
- Still not connected, so I did "pump -i wlan0", wait for a while then "Operation failed". The dmesg shows
Code:
ndiswrapper version 1.51 loaded (smp=yes, preempt=yes)
ndiswrapper: driver net5513 (D-Link,12/23/2004,1.0.0.28) loaded
PCI: Enabling device 0000:02:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:02:00.0 to 64
ndiswrapper: using IRQ 11
wlan0: ethernet device 00:15:e9:6c:3e:c7 using serialized NDIS driver: net5513, version: 0x10000, NDIS version: 0x501, vendor: 'NDIS Network Adapter', 168C:0020.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA; AES/CCMP with WPA
usbcore: registered new interface driver ndiswrapper
ADDRCONF(NETDEV_UP): wlan0: link is not ready
ADDRCONF(NETDEV_UP): wlan0: link is not ready
In case this relates. In 5.3.1, I need to specify cheatcode "apci=force" otherwise I will get:
Kernel panic - not syncing: Attempted to kill init!
Clocksource tsc unstable (delta = 286584614 ns)
Time: pit clocksource has been installed.[/list]
Similar Threads
-
By Silvix in forum Networking
Replies: 0
Last Post: 06-02-2005, 04:02 AM
-
By CrashedAgain in forum Networking
Replies: 1
Last Post: 10-26-2004, 09:28 PM
-
By Corwin in forum Hdd Install / Debian / Apt
Replies: 2
Last Post: 04-04-2004, 03:29 AM
-
By BluntMan in forum Networking
Replies: 0
Last Post: 11-17-2003, 01:28 AM
-
By Mokoshi in forum Networking
Replies: 1
Last Post: 10-07-2003, 03:04 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
![GIGABYTE B450M DS3H WIFI (AMD Ryzen AM4/M.2/HMDI/DVI/USB 3.1/DDR4 Motherboard picture](/store/img/oaoAAOSwl2RkUzG5/s-l225//GIGABYTE-B450M-DS3H-WIFI-AMD-Ryzen-AM4-M-2-HMDI-DV.jpg)
GIGABYTE B450M DS3H WIFI (AMD Ryzen AM4/M.2/HMDI/DVI/USB 3.1/DDR4 Motherboard
$64.99
![ASUS H110M-R Motherboard Intel 6th/7th Gen LGA1151 DDR4 Micro-ATX i/o shield picture](/store/img/FhQAAOSwzL9iDqc3/s-l225//ASUS-H110M-R-Motherboard-Intel-6th-7th-Gen-LGA1151.jpg)
ASUS H110M-R Motherboard Intel 6th/7th Gen LGA1151 DDR4 Micro-ATX i/o shield
$42.00
![Gigabyte GA-Q170M-D3H-GSM LGA1151 DDR4 Desktop Motherboard w/ I/O Plate picture](/store/img/lIMAAOSwF5BmkHwt/s-l225//Gigabyte-GA-Q170M-D3H-GSM-LGA1151-DDR4-Desktop-Mot.jpg)
Gigabyte GA-Q170M-D3H-GSM LGA1151 DDR4 Desktop Motherboard w/ I/O Plate
$49.99
![Asus Prime H310M-A R2.0 Intel LGA 1151 DDR4 Desktop Motherboard picture](/store/img/MIEAAOSwj61mmkfY/s-l225//Asus-Prime-H310M-A-R2-0-Intel-LGA-1151-DDR4-Deskto.jpg)
Asus Prime H310M-A R2.0 Intel LGA 1151 DDR4 Desktop Motherboard
$54.99
![Asus Prime A320M-K mATX AM4 Motherboard (Ryzen 1000-5000 Ready) picture](/store/img/v2sAAOSwFuxlhzOj/s-l225//Asus-Prime-A320M-K-mATX-AM4-Motherboard-Ryzen-1000.jpg)
Asus Prime A320M-K mATX AM4 Motherboard (Ryzen 1000-5000 Ready)
$49.99
![Asus Prime H570-PLUS LGA1200 ATX Motherboard | Fast Ship, US Seller picture](/store/img/sUsAAOSw2~dloH2z/s-l225//Asus-Prime-H570-PLUS-LGA1200-ATX-Motherboard-Fast-.jpg)
Asus Prime H570-PLUS LGA1200 ATX Motherboard | Fast Ship, US Seller
$64.97
![GIGABYTE GA-X99-UD4P MOTHERBOARD, M.2 SATA3, LGA2011-3, DDR4, & I/O Shield picture](/store/img/ZI0AAOSwKLBmV33e/s-l225//GIGABYTE-GA-X99-UD4P-MOTHERBOARD-M-2-SATA3-LGA2011.jpg)
GIGABYTE GA-X99-UD4P MOTHERBOARD, M.2 SATA3, LGA2011-3, DDR4, & I/O Shield
$69.99
![ASRock B550M Pro SE AM4 DDR4 SATA 6Gb/s 1 PCIe 4.0 x16 Micro ATX Motherboard picture](/store/img/oXIAAOSwCn1k30lD/s-l225//ASRock-B550M-Pro-SE-AM4-DDR4-SATA-6Gb-s-1-PCIe-4-0.jpg)
ASRock B550M Pro SE AM4 DDR4 SATA 6Gb/s 1 PCIe 4.0 x16 Micro ATX Motherboard
$84.99
![ASUS B85M-E Motherboard Intel B85 (4th Gen) LGA1150 DDR3 microATX picture](/store/img/sjQAAOSw8blmdbCX/s-l225//ASUS-B85M-E-Motherboard-Intel-B85-4th-Gen-LGA1150-.jpg)
ASUS B85M-E Motherboard Intel B85 (4th Gen) LGA1150 DDR3 microATX
$39.99
![ASUS PRIME Z690-P WIFI D4 ATX Motherboard Intel LGA1700 DDR4 HDMI picture](/store/img/gR8AAOSwhlJkracH/s-l225//ASUS-PRIME-Z690-P-WIFI-D4-ATX-Motherboard-Intel-LG.jpg)
ASUS PRIME Z690-P WIFI D4 ATX Motherboard Intel LGA1700 DDR4 HDMI
$99.99