One of the things I miss about the older versions of Knoppix is the verbose mode of booting where I see the hardware as Knoppix is discovering it. Is there a way I can still display this information at boot time? The information displayed is very minimal compared to the older versions.
I used to use Knoppix heavily for diagnostic issues, but it's not as useful for that without the verbose boot screen...
Hello,
And how could you put this in menu.lst
Or can't?
Thank you.
Alix.
OWC Guardian Maximus Raid Enclosure SATA Hard Drive FireWire
$36.99
Dell EMC 092GD6 Broadcom 9305-16i LSI Quad Port 4 Port SAS RAID Controller
$84.99
Yottamaster 2 Bay RAID Hard Drive Enclosure USB 3.1 For 2.5" SATA HDD SSD UASP
$56.25
Yottamaster 5 Bay RAID Hard Drive Enclosure Type-C B For 2.5" 3.5" SATA HDD SSDs
$131.59
Dell PERC H330 PCIe 3.0 x8 RAID Storage Controller 4Y5H1 High Profile
$17.99
LSI MegaRAID 93614I Raid Controller Card
$37.99
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
LSI 8 Port 6Gbps PCIe 3.0 External SAS RAID Card w/ 1GB CacheVault & Low Profile
$29.00
Yottamaster 2 Bay RAID Hard Drive Enclosure USB 3.1 Type B For 3.5" SATA HDDs
$69.91
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$54.66