-
Using fdisk on a large device
Hello,
Yesterday I tried to format a 2TB drive using fdisk. There are 243201 cylinders and I wanted to set
/dev/sdd1 cyls 1 - 243000 type 83 Linux
/dev/sdd2 cyls 243001 - 243201 type 82 swap
and went through the usual fdisk n (new) p (primary) 1 (partition no) 1 (start) 243000 (finish) n (new) p (primary) hoping to set up a 2nd partition starting at 243001 but got the message "no available sectors".
I've used fdisk many times (on smaller devices up to 640G) and never got this before. It's as though fdisk is defeated by the large numbers?
I guess I could try setting up the swap partition on /dev/sdd1 using cylinders 1 to 200 and then use 201 to 243201 for /dev/sdd2 but it would be quaint that fdisk allows one architecture but not another, almost equivalent.
Anybody seen this before? Should I have anticipated it?
Thank you.
Fergus
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.80