-
Junior Member
Removing lxde
I prefer Gnome. I installed gdm and gnome. Then I removed lxde and openbox. When booting/rebooting openbox tries to reboot, fails and shuts down X, which then immediately restarts. This is an endless loop.
How do I set gdm as the default?
-
Since the cheatcodes say
Code:
knoppix desktop=kde|gnome|icewm
and you've installed gdm, I suggest trying
Code:
knoppix desktop=gdm
to start with; once it's proven, I think you can use the System config in the Preferences menu to set it permanently.
Cheers!
Krishna
-
Junior Member
Thank you for the reply. I should have said I have installed knoppix to hd. The opening screen allowing the entry of cheat codes does not come up.
I assume that the cheat codes are stored in a file somewhere. I could possibly edit that file to "desktop=gnome" None of this may be of any use. The 6.2 cheat code wiki says that "gnome" is not a valid variable for desktop.
-
Senior Member
registered user
I would suggest the creation of a file /etc/sysconfig/desktop with the line /etc/init.d/knoppix-startx reads that file and uses its content to select the gnome desktop environment. Edit: I think there should be quotation marks around gnome. But how do I enter those in this forum? Every time I tried I got the HTML &"
Last edited by klaus2008; 05-17-2010 at 08:31 PM.
-
Junior Member
Originally Posted by
klaus2008
I would suggest the creation of a file /etc/sysconfig/desktop with the line
/etc/init.d/knoppix-startx reads that file and uses its content to select the gnome desktop environment. Edit: I think there should be quotation marks around gnome. But how do I enter those in this forum? Every time I tried I got the HTML &"
Klaus, that was the solution. Thanks a bunch.
-
Originally Posted by
klaus2008
I think there should be quotation marks around gnome. But how do I enter those in this forum? Every time I tried I got the HTML &"
I find that "gnome" will work. Where are you puttiing that in, Code block like this one?
Maybe it's okay because I'm on a Mac in Opera at the moment.
Krishna
-
Junior Member
[code]SESSION=gnome[/code|
worked just fine without the ""
I still seem to be using openbox however. Is there a config file I can edit to change to gdm?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS ALTAIR 8800 88-2SIO S-100 Reproduction Board
$35.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00