try "pppconfig" and then "pon provider-name" .to disconnect poff
I am having problems starting ppp in my debian installed with knx-hdinstall. I can dial in to my server and succesfully login but ppp does not appear to start. I cannot ping or get to any websites. Are there any modules or any pppd config files that I need to set up?
Thanks.
try "pppconfig" and then "pon provider-name" .to disconnect poff
I had the exact problem and not sure exactly how I fixed it. fist if your modem was ttyS4, use ./MAKEDEV ttyS4 to make it, then ln -s ttyS4 modem so kppp can see it. Try chmod 777 to both ttyS4 and modem. try route -n, while your are online you should get 2 lines and they both should end in ppp. try ifconfig eth0 down. try netcardconfig too. If you find out what did it post back. check /etc/resolv.conf to see numbers are good also resolv.conf in /etc/ppp. read man resolv.conf. Try to access google without name 216.239.37.101
Somewhere in there is solution. Don't give up.
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
Lot of 10 SFP-10G-SR V03 Original CISCO 10-2415-03 10GBASE-SR Multi mode Module
$60.00
New Cisco w/ Green Hologram SFP-10G-LR-S 10G SFP+ LR 1310nm 10km SMF LC Module
$34.99
Green label hologram Cisco SFP-10G-LR-S SFP Transceiver Module
$28.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
DELL SFP 25G SFP28-25G-SR-85C LTF8505-BE+-DEN1 Optical Transceiver 0HHHHC
$17.50
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$25.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$10.99
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00