Greetings Knoppix Forums,
I am a fan of Knoppix.
Recently I installed 6.2.1 to a 4Gb pen drive.
It boots and runs flawlessly on my old Dell Pentium M's.
However it has a fatal issue with my newer Dell Turion 64 about 2 seconds into boot. I tried booting failsafe and without hardware detection to no avail.
(Guess that is an obvious enough message from sh.)Linux Kernel 2.6.32.6, 1895 MB RAM
CPU 0: AMD Turion 64 X2 Mobile Technology TL-60 @ 1994MHz, 512 KB Cache
Knoppix 6 found at: /dev/sda1
. . .
insmod: cannot insert ' /mnt-system/KNOPPIX/modules/cloop.ko': Invalid module format (-1): Exec format error
Could not mount /mnt-system/KNOPPIX/KNOPPIX. Starting debugging Shell . . .
sh: can't access tty; job control turned off
I have been using and tinkering with Debian for 5 or 6 years but I am not real techie so I am hopping for some pointers!
Regards,
Freeman
Yep. Right in front of my face.
So I searched my Vista partition for Knoppix. But /dev/sda1 was a hidden 48MB partition with a failed install that must have been a mistaken attempt during install to Pen Drive. I had to un-hide it /dev/sda1 with gparted because Vista is, well, Vista.
All is good. Knoppix rocks!
Thanks!
Dell PowerEdge R7525 Server 24X2.5(8XNVME)+H745 2xEPYC 7302 CPU 128G RAM 2x2400W
$3350.00
Dell PowerEdge R720XD Xeon E5-2680 V2 2.8GHz 20 Cores 256GB RAM 12x4TB
$510.00
Dell PowerEdge R620 Server 2x E5-2660 v1 2.2GHz 16 Cores 256GB RAM 2x 300GB HDD
$79.19
Dell PowerEdge R730XD 28 Core Server 2X Xeon E5-2680 V4 H730 128GB RAM No HDD
$389.99
Dell PowerEdge R720 Server - 2x8c CPU,256Gb RAM, 128Gb SSD/3x900Gb SAS, Proxmox
$340.00
Dell PowerEdge R730, 2 sinks, SystemBoard, 8 trays,H330,Idrac 8 exp, 2x750w Psu
$135.00
Dell Poweredge R730xd 2.5in 2x E5-2690 v3 2.6ghz 24-Cores 64gb H730 2x 750w
$189.99
CTO Dell PowerEdge R630 Server, 2x Xeon E5-2620V4, 64GB- 512GB RAM, 480GB SSDs
$246.67
DELL PowerEdge R730 Server 2x E5-2680v4 2.4GHz =28 Cores 32GB H730 4xRJ45
$284.00
DELL R730XD Server 2x E5-2680v4 2.4GHz =28 Cores 128GB H730 4x 1.2TB SAS 4xRJ45
$504.00