Greetings Knoppix Forums,
I am a fan of Knoppix.
Recently I installed 6.2.1 to a 4Gb pen drive.
It boots and runs flawlessly on my old Dell Pentium M's.
However it has a fatal issue with my newer Dell Turion 64 about 2 seconds into boot. I tried booting failsafe and without hardware detection to no avail.
(Guess that is an obvious enough message from sh.)Linux Kernel 2.6.32.6, 1895 MB RAM
CPU 0: AMD Turion 64 X2 Mobile Technology TL-60 @ 1994MHz, 512 KB Cache
Knoppix 6 found at: /dev/sda1
. . .
insmod: cannot insert ' /mnt-system/KNOPPIX/modules/cloop.ko': Invalid module format (-1): Exec format error
Could not mount /mnt-system/KNOPPIX/KNOPPIX. Starting debugging Shell . . .
sh: can't access tty; job control turned off
I have been using and tinkering with Debian for 5 or 6 years but I am not real techie so I am hopping for some pointers!
Regards,
Freeman
Yep. Right in front of my face.
So I searched my Vista partition for Knoppix. But /dev/sda1 was a hidden 48MB partition with a failed install that must have been a mistaken attempt during install to Pen Drive. I had to un-hide it /dev/sda1 with gparted because Vista is, well, Vista.
All is good. Knoppix rocks!
Thanks!
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.99
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon
$846.19
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD
$249.99
Supermicro 5018A-FTN4 Rack Server - Black
$125.00
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00
1U 20" Short Depth Server Firewall PFSense X11SSH-F Xeon 3.5Ghz 32GB RAM NVME
$247.00
1U Supermicro Server X10DRU-i+ 2x Xeon E5-2690 V4 28 Cores 64GB 4x 10GBE-T 2PS
$324.00