Greetings Knoppix Forums,
I am a fan of Knoppix.
Recently I installed 6.2.1 to a 4Gb pen drive.
It boots and runs flawlessly on my old Dell Pentium M's.
However it has a fatal issue with my newer Dell Turion 64 about 2 seconds into boot. I tried booting failsafe and without hardware detection to no avail.
(Guess that is an obvious enough message from sh.)Linux Kernel 2.6.32.6, 1895 MB RAM
CPU 0: AMD Turion 64 X2 Mobile Technology TL-60 @ 1994MHz, 512 KB Cache
Knoppix 6 found at: /dev/sda1
. . .
insmod: cannot insert ' /mnt-system/KNOPPIX/modules/cloop.ko': Invalid module format (-1): Exec format error
Could not mount /mnt-system/KNOPPIX/KNOPPIX. Starting debugging Shell . . .
sh: can't access tty; job control turned off
I have been using and tinkering with Debian for 5 or 6 years but I am not real techie so I am hopping for some pointers!
Regards,
Freeman
Yep. Right in front of my face.
So I searched my Vista partition for Knoppix. But /dev/sda1 was a hidden 48MB partition with a failed install that must have been a mistaken attempt during install to Pen Drive. I had to un-hide it /dev/sda1 with gparted because Vista is, well, Vista.
All is good. Knoppix rocks!
Thanks!![]()
Juniper EX2300-C-12P, 12 Port FANLESS POE Ethernet Switch EX2300-C
$375.00
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX2200-C Gigabit Ethernet Managed Switch | EX2200-C-12P-2G
$49.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3400-48P 48 Port Switch PoE+ 4x SFP+ 2x QSFP 1xAC *Tested/Warranty*
$139.95
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper QFX5100-48T 48-Port 10G SFP 6-Port 40G QSFP Ethernet Switch Tested
$312.69
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1200.00
Juniper Networks EX2300-48P 48-Port PoE+ Network Cloud-Ready Ethernet Switch
$104.99