-
Using a serial mouse on Knoppix 6.2.1 graphical environment
I'm using an old laptop and I want to use a serial mouse instead of using the built-in touchpad of the laptop I'm using. There's no problem on BIOS setting of the laptop regarding input device configurations, all settings on the BIOS are correct. I plugged-in the serial mouse on COM1 on the laptop before starting it to run. After knoppix finally loaded and ready to use, and as I move the serial mouse, it doesn't move the mouse cursor, but when I use the touch pad of the laptop, the mouse cursor moves. What shall I do? Help please... I'm very new to Linux.
-
Senior Member
registered user
I think you should install the package inputattach and use that program to configure your serial mouse.
Example: I have got a serial Logitech mouse with a wheel plugged-in on COM1. Thus I would enter the following command in a terminal.
Code:
sudo inputattach --daemon -mmw /dev/ttyS0
The manual page explains which serial devices are supported. You could also enter to get a list of supported serial input devices.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Knoppix NSM 1.2
$6.40
Knoppix Live GNU Linux System 9.1 on Bootable CD / DVD / USB Flash Drive
$9.99
Linux Knoppix 4.0.2 Installation Disc
$29.99
KNOPPIX 9.1 LINUX INSTALL & LIVE DVD
$9.99
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 32G USB Stick
$20.30
Hamshack Live DVD-ROM
$8.00
Acer Aspire One 9 inch Netbook ZG5 512MB RAM 8GB SSD HD Knoppix Linux WiFi VGA
$79.99
Knoppix 3.4 Linux installation CD
$10.00
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 16G USB Stick
$19.95