Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
Juniper Networks (EX3300-48P) 48 Ports Rack Mountable Ethernet Switch
$475.00
Juniper MX204 +JUNOS and Dual Power Supply + Rack Mount-LIFETIME WARRANTY
$8395.00
Juniper EX2300-C-12P 12 Port Rack Mountable Ethernet Switch w/Rack Mount Ears
$350.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Ethernet Switch EX2200-C - 12 Port Switch
$89.99
Juniper Networks EX2300 -24P 24 Port Gigabit PoE Network Switch
$149.00
Juniper Networks SRX345 Service Gateway 8 Port Gigabit 8 SFP 1G
$229.00
Juniper QFX5100-48T-AFI 48-Port 10G SFP 6-Port 40G QSFP Ethernet Switch Dual PSU
$449.99
Juniper QFX5200-32C-AFO QFX5200 32 Port QSFP 40/100G AFO Front to Back Airflow
$1349.00
Juniper Networks EX4550-32F-AFI 32 Port 10G SFP Back to Front Airflow Dual PSU
$349.00