Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
Vintage DEC/CLEARPOINT INC. -QRAM-2 SAB-1 1MB Q-BUS MEMORY MSV11-QA (B2)
$129.99
VINTAGE DEC Digital RK11-D DISK CONTROL M7255 PDP 11 (B1)
$129.99
Vintage DEC/The Redac mini cabinet front panel Digital Equipment Corp. 19"
$269.99
DEC DIGITAL Equipment Corp VT220-D2 Vintage CRT Terminal
$215.00
Digital Equipment Corporation DEC-2000 Vintage Keyboard - NOS NEW in Plastic
$129.95
DEC PDP 8/M PDP 8M / 4 avail / Vintage Digital Equipment Corp /Also DEC PDP 12
$5775.00
Vintage DEC Digital RX 180 AB Dual 5.25" Disk Drive
$149.00
Rare Vintage DEC DIGITAL DFO3 modem with manual Powers up but UNTESTED
$69.95
VINTAGE DEC DIGITAL H866 MEM BUS TERM 100 OHM
$229.00
VINTAGE DEC DIGITAL RA81 READ/WRITE 5415253 Circuit board (B18)
$119.99