FWIW, no significant delay in normal (not pxe) use of dhcp.
Im booting Knoppix 6.7 via pxe. Once Knoppix starts to load I get delay in DHCP during boot. The sending dhcp message appears for quiet some time. Then knoppix goes about its boot. The unit has an ip from the pxe process. So my question is, is this a knoppix delay or my pxe server? Any ideas?
Thanks!
FWIW, no significant delay in normal (not pxe) use of dhcp.
So called normal use of DHCP within Knoppix doesnt begin until after X has started/loaded. Knoppix needs IP before X when pxe booting. I think it may be within minirt.gz the ini file itself. ?
I've contributed all I know for sure on this.
But if pxe needs IP early, why isn't the server providing it already?
Are you able to decode minirt.gz and read the init?
Yes, Ive just started to dig thru ini. I think DHCP server is confused by knoppix asking for an ip from the same mac addy that just requested ip?
FWIW,
In 6.4.4 my LiveUSB took almost 120 seconds to get on-line initially.
I finally disabled Network Manager and got down to about 55-or so seconds
using a primitive /etc/rc.local routine to get my wifi going.
In 6.7, there was no similar slow start to getting on-line in less than
a minute and no need to circumvent Network Manager.
Obviously either Knoppix or Network Manager must have changed between
6.4.4 and 6.7. If you don't find the answer in minirt.gz, then you might
see if there's some difference in NM that explains your situation.
Thanks for those ideas. I will post my findings. May take me a few days.
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD
$249.99
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.99
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon
$846.19
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
Supermicro 5018A-FTN4 Rack Server - Black
$125.00
Microsel Server Tower Supermicro X10SAE E3-1275 V3 @3.5GHz 16GB 509849-001
$149.99
1U Supermicro Server X10DRU-i+ 2x Xeon E5-2690 V4 28 Cores 64GB 4x 10GBE-T 2PS
$324.00
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00