Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
Apple Macintosh SE/30 M5119 Computer 8MB RAM Recapped Working *See Description*
$475.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$229.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
Apple IIc Analog Board NOS - 661-0265
$74.00
Two (2) vintage The Analog Computing Pocket Reference Cards, 1985
$19.99
ACASIS PCIE Capture Card HDMI 1.4 1080P60HZ PCIE 2.0 X4 20Gbps for Video Capture
$248.99