Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
Vintage 60s Heathkit Ec-1 Educational Electronic Analog Computer W Extras Ec 1
$3000.00
NEW Aquarius+ Mini 8Bit Retro Computer System - Assembled PCB ONLY
$99.00
IBM Modem Saver Phone Line Tester
$7.99
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
FULLY RECAPPED MACINTOSH CLASSIC II 2 VINTAGE MAC APPLE COMPUTER NEW BATT WORKS
$899.00
Macintosh Plus, BlueSCSI, OS 6.x, 4 mb memory - recapped, tested, working.
$715.00
Macintosh Classic/Classic II Analog Board Computer 630-0395 New
$278.00
FOSSIL Q Wander Watch Gen 2 Touch Screen LCD ASSEMBLY - GOLD DW2B
$129.99