Hi all,
I'm trying to get ANY distro onto a C3 based board but keep coming up against the CMOV issue, everyone is still compiling for i686 and labelling as i386 it seems. Is knoppix doing the same and is there a version compiled without the requirement for CMOV or am I basically forced into junking this board?
Cheers!
OK, cheers - so from what I can tell i486 should run fine on an eden processor without cmov etc. Thanks, I didn't want to download the ISO to check the config file (limited bandwidth) and wasn't sure where to find an example of it outside there.
Ta
Lot of 10pcs Brocade 57-1000012-01 8Gbps SWL 850nm SFP+ Optical Transceivers
$19.00
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100LX 100BASE-LX SFP Transceiver Module
$15.59
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
Cisco C3850-NM-2-10G 2-Port 10GB SFP Network Module for 3850 Switches
$38.99
SolarFlare XtremeScale X2522-10G-PLUS Dual Port 10GbE SFP28 PCI-E 3.1 x8 NIC
$149.95