Hi all,
I'm trying to get ANY distro onto a C3 based board but keep coming up against the CMOV issue, everyone is still compiling for i686 and labelling as i386 it seems. Is knoppix doing the same and is there a version compiled without the requirement for CMOV or am I basically forced into junking this board?
Cheers!
OK, cheers - so from what I can tell i486 should run fine on an eden processor without cmov etc. Thanks, I didn't want to download the ISO to check the config file (limited bandwidth) and wasn't sure where to find an example of it outside there.
Ta
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.12
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper EX4600-40F-AFI 24 SFP+/SFP Ports 4 QSFP+ Ports Dual AC Switch
$999.00
JUNIPER EX3300-48T 48 PORT SWITCH TESTED & RESET w/ Rack Ears
$49.99
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00
Juniper Networks EX3300-48T 48-Port PoE+ Gigabit Ethernet Switch 4x SFP+ TESTED
$99.99