.
I think there is a need for some built-in protection in Knoppix 6.7
to prevent the ruination of LiveUSBs that have been given a task that
turns out to be catastrophic.
What I have in mind is the bad result which occurs after starting a
download that proves ultimately too large for the LiveUSB to accommodate.
This ultimately fails, but also renders the LiveUSB inoperable without
extensive repairs or re-installation.
Couldn't there be some built-in surveillance to monitor for this
condition and head it off with some timely warning or corrective action?
Training the operator and/or using a larger USB are not solutions of interest.
@ vkrishn
For example:
I now have about 400 MB unused on my LiveUSB with persistence.
If I were to initiate a 700 MB download, that would proceed
until the device was 'full' at which time I would get a
warning 'no more room on the device'.
At this point the LiveUSB is corrupted and will not reboot
after shutdown. I think some some protection against this condition
is in order.
The few work-arounds I've tried are all harder than simply
re-installing from a previously arranged clone copy of the LiveUSB.
I guess that means using the space on disk directly and not inside the persistent storage.
The reason I asked, I have few usb installation wanted to be careful.
Did you try installing Knoppix in one partition of the disk and persistent/downloads on another partition, to see if the problem still exists?
Here are two ideas:
1. One could change IceWeasel's Edit>Preferences>General>Downloads
FROM: 'Save files to {/home/knoppix/Downloads}'
TO: 'Always ask always ask me where ...'
2. If there is a 'good' answer to 'where' then one might change the
default to that, instead of 'ask me where'.
Leaving IceWeasel set to its download default is asking for trouble
for those downloading into OS media of relatively limited size.
And you cannot reboot with cheatcode "knoppix noimage"? Of course your persistent memory is damaged, but you can use your backup.At this point the LiveUSB is corrupted and will not reboot
after shutdown.
Thanks, Werner.
The 'noimage' approach is one means of RECOVERY that I've used.
What I was searching for here is a means of PREVENTION.
What with the cost of USBs coming down, there's not much
justification anymore for 2 Gb installs like I've championed up to now.
My favorite current configuration is a 16 Gb USB with 2 GB partition
and the remainder formatted ext3 with kn-recombine on it.
I can just as well shift downloads to that partition and not run
into the 'disasters' anymore.
Cheers.
HyperX FURY DDR4 16GB 32GB 64GB 2666MHz PC4-21300 Desktop RAM Memory DIMM 288Pin
$119.80
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Team T-FORCE VULCAN Z 16GB (2 x 8GB) 288-Pin PC RAM DDR4 3200 (PC4 25600) XMP
$35.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
Crucial 16GB (2x 8GB) Kit DDR3L 1600MHz PC3-12800 UDIMM Desktop 240-Pin CL11 RAM
$23.33
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$21.50
64GB (4X16GB) DDR3 1866 DIMM Apple Mac Pro Late 2013 A1481 MacPro 6,1 Memory Ram
$37.49
HyperX FURY DDR4 16GB 3200 MHz PC4-25600 Desktop RAM Memory DIMM 288pin 2x 16GB
$127.20
A-Tech 64GB 4x 16GB 2Rx4 PC4-17000R DDR4 2133MHz ECC REG RDIMM Server Memory RAM
$87.96