Creating a boot floppy for Knoppix 6.4.4 seems impossible since the Linux kernel is too big to fit on a single floppy disk.
How to create boot floppy? Knoppix 6.4.4 CD.
Creating a boot floppy for Knoppix 6.4.4 seems impossible since the Linux kernel is too big to fit on a single floppy disk.
What's the latest version of Knoppix that will install on a USB stick, and have a kernel small enough to have on a boot floppy?
Your best hope is to chain boot, ie boot from floppy without the knoppix kernel, and chain boot into the USB stick. There is no knoppix kernel which is small enough to fit a floppy..
How do I chain boot?
There maybe more than one ways to do it.
But you can try this method which uses 'plop', ie you boot up from floppy using plop, then plop has built-in (usb) drivers to boot into linux resided on the usb.
Information on the net :-
http://www.linuxquestions.org/questi...anager-779779/
http://www.plop.at/
NEW Sealed Original Cisco SFP-10G-SR 10G SR SFP+ Module 850nmMM *US Shipping*
$18.00
HP Aruba J9150D 10GBASE-SR SFP+ Transceiver Module 850nm 300m MMF LC
$65.00
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.90
Cisco SFP-10G-SR V03 10-2415-03 10GBASE Multimode Fiber Optic Transceiver Module
$6.98
Cisco GLC-TE 1000BASE-T SFP Copper RJ-45 100m - 01478
$24.99
Finisar FTLX8571D3BCL SFP+SR/SW 10Gb/s 850nm Multimode SFP+ Transceiver
$7.70
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.90
Lot of 8, Brocade 57-0000075-01 10GB SFP+ Transceiver Modules
$29.95
For Mikrotik S+RJ10 SFP to RJ-45 module 10G SFP+ 10Gbase-T Copper Transceiver
$57.99
2 Packs for Cisco SFP 10G T 10GBase-T Transceiver 10G SFP+ to RJ45
$99.00