I would suggest that you try to boot without the 'debug' cheat code.
I have an older Dell Inspiron whose CD drive does not work, and whose bios dose not allow booting from a usb device. So, I downloaded the ADRIANE iso to the hard drive (it currently runs xubuntu) and configured grub with this boot entry:
menuentry knoppix {
loopback loop (hd0,1)/home/ADRIANE....iso
linux (loop)/boot/isolinux/linux debug nousb bootfrom=/dev/sda1/home/ADRIANE....iso expert knoppix
initrd (loop)/boot/isolinux/minirt.gz
}
When I boot the computer, Knoppix appears to boot ok --it displays a message that it finds knoppix 6 at /dev/sda1/home/.... It displays a messages that kernel 2.6.39.3 is loaded. Then it displays a message:
sh: can't access tty; job control turned off
It then displays a prompt. The hard disk is mounted at /mnt-iso. I cannot run any programs on the hard disk such as firefox. Even if I type the full path, a message is displayed that the program is not found. A character interface is displayed -- no graphical windows manager. Obviously somethins is wrong. Any ideas?
Thanks much!
I would suggest that you try to boot without the 'debug' cheat code.
Alright. It worked! I presumed that "debug" would offer something useful if the boot malfunctioned, and that it would be harmless if it functioned well. I was wrong. Thanks much for your assistance.
Cheers!
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX2200-C-12P-2G 12 Port Gigabit PoE 2 T/SFP 1G Network Switch
$129.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$41.43
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
JUNIPER EX4550-32F-AFO 32-PORT ETHERNET SWITCH 2x POWER SUPPLY - TESTED
$299.99
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00