-
Senior Member
registered user
BCM4312 & 4322 intermittence description & work-around for Knoppix 7
.
After three years of faithful service, the wifi in my Dell 1545 Laptop
began being intermittently troublesome. Left on-line for a few hours
unattended, I would find the wifi not only dead, but whatever it finds
in knoppix-data.img would not allow me to get re-connected. I had to
re-establish persistent store to get on-line again.
I went to Dell's on-line store, gave them my product ID and found there
was a re-furbished wifi for $22 plus tax with free shipping. On this
same site I was able to download an illustrated owner's manual which
spelled-out how I might easily remove and replace the wifi. The $22
replacement arrived in a few days and I was able to do the physical part
of the replacement in mere minutes.
The wifi provided was not an exact replacement, but a slight 'upgrade'
from a/b/g to a/b/g/n. The original and the replacement have different
part numbers, but seem to be operationally interchangeable. The original
was a BCM4312, Dell part nr DW-1397; the replacement a BCM4322, DW-1510.
Both Windows 7 and Knoppix 7 easily found and correctly installed drivers.
The Windows 7 driver installation said, incorrectly, that its install
was 'unsuccessful'.
I was pleased with my diagnosis and my bargain and my successful repair.
For a while, that is. Guess what, the replacement wifi pretty much
matches the original, including my complaint of infrequent intermittence.
So, here's a more complete statement of the intermittence. Very
infrequenly, if I leave my CD-size LiveUSB on-line with no keyboard
activity I may return and find the wifi connection gone, AND the
driver unloaded from the Linux kernel. The connection does not re-
establish itself, even on reboot, without some help.
There are two simple work-arounds that solve my problem for all practical
purposes. First, if I notice a dropped connection, I can get back on-line,
without rebooting, with sudo modprobe b43. Second, I might double-down
by adding, as root, b43 to my /etc/modules file to make sure b43 gets
loaded at boot.
Both the original and the replacement wifis are among those which
the b43/linuxwireless.org folks say work both with b43 and wl drivers.
In Knoppix 6.7.1, with the original wifi I never saw this intermittence
with either driver; however, my experience was mostly with the wl driver,
I only used the b43 driver for a short time before the advent of Knoppix 7.
In Knoppix 7, there is currently only a b43 option. I've seen the
intermittence in both the original and replacement wifis.
-
Senior Member
registered user
Continued
In the event of a router failure, things go from bad to worse.
Somehow the default Bit Rate for the 4322 gets set to the default auto
which may in turn deteriorate to 1M instead of 54M in a 'noisy' wifi
neighborhood.
I thought I might simulate conditions that would throw wifi off-line
by interrupting the router, but I find that creates additional problems
not observed earlier. My temporary remedy for this self-imposed problem
is to add 'sudo iwconfig wlan0 rate 54M' to /etc/rc.local. It will
take some detective work to find just where the rate is configured by
Linux and to change the rate definition more directly.
I've not seen the original mode of failure, that is, a failure following
keyboard inactivity, since I added 'b43' to /etc/modules. It may be too
premature to say that's what has been missing in Knoppix 7, but I notice
Ubuntu b43 users add this little wrinkle.
-
Senior Member
registered user
Recommendation:
.
After two weeks of use, I recommend the following minor adjustments to
Knoppix 7.0.4 to handle infrequent Broadcom BCM-4322 wifi connection
interruptions using a b43 wifi driver.
1. Add 'b43' to /etc/modules; and
2. Add 'sudo iwconfig wlan0 rate 54M' to /etc/rc.local,
assuming wlan0 is the wifi device in question.
These adjustments seem to handle my situation adequately.
-
Senior Member
registered user
b43 wifi disconnects persist in Knoppix 7.0.5
.
Greetings, Fellow Broadcom b43 wifi users.
I think the new Knoppix 7.0.5 may have a similar problem that 7.0.4 had.
After a period of wifi connection in a crowded internet environment,
and no activity,
I occasionally find my b43 wifi is disconnected, no longer listed on the
wifi icon list and no longer looking to get re-connected. This is always
remedied by a reboot. The problem occurs rarely, and perhaps more
rarely in 7.0.5 than 7.0.4.
Similar complaints exist over may Linux distros with no real solutions
offered that I have found, other than the reboot, that is.
In Knoppix 7.0.4, I thought I might have cured this problem by adding
b43 to /etc/modules. My hope was that this might aid networkmanager to
re-install b43 if ever it is removed from the kernel due to inactivity.
I'd be interested in other b43 users' experiences in 'crowded' internet
environments, and what if any solutions they may have tried if they have
encountered this b43-disconnect phenomenon. Probably any Knoppix 7 b43
has this difficulty to some degree.
Last edited by utu; 12-27-2012 at 10:49 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Dell PowerEdge T420 2x Xeon E5-2430 V2 2.50GHZ 32GB DDR3-1600MHZ 2x 550W PSU
$149.95
Dell PowerEdge R730 2x E5-2699V3 2.3Ghz 36 Core 128GB RAM H730 X520-I350 2x750W
$329.99
Intel Xeon E5-2697 v4 2.3GHz 18-Core Processor CPU LGA2011 SR2JV
$49.99
HP Z230 Workstation Towers Xeon E3-1231 V3 3.20ghz 8GB Ram NO HDD
$35.96
SR1XP Intel Xeon E5-2680 v3 12 Core 30MB 2.5GHz LGA 2011-3 Grade A Processor
$3.96
Genuine Intel Xeon E5-2680V4 2.40Ghz 14-Core 35MB LGA2011 CPU P/N: SR2N7
$14.99
Intel Xeon E5-2699 v3 2.3GHz 18-Core 45MB 145W LGA2011-3 CPU/Processor SR1XD
$40.99
Intel Xeon Gold 6140 SR3AX 2.3GHz 18-Core Processor CPU
$32.79
Dell Poweredge R730xd LFF 14-Bay 2U Server | Choose Your CPU & RAM Config
$489.99
Apple MAC Pro A1481 Late 2013 Xeon Quad-Core 3.7GHz 16GB 1TB SSD FirePro D300
$235.00