-
Senior Member
registered user
Boot from Knoppix ISO in HDD using grub
I used the following code:
Code:
menuentry "Knoppix ISO" {
insmod part_msdos
insmod ext3
set root=(hd0,msdos2) #the partition where you've stored knoppix iso
loopback loop /KNOPPIX_V7.0.4DVD-2012-08-20-EN/KNOPPIX_V7.0.4DVD-2012-08-20-EN.iso
linux (loop)/boot/isolinux/linux boot=isolinux iso-scan/filename=/KNOPPIX noeject noprompt --
initrd (loop)/boot/isolinux/minirt.gz
}
everything works, then knoppix iteratively searchs KNOPPIX in /dev/sdax for a few times and lets go.
Where I am going wrong?
--------------------
formatted by mod
Last edited by Werner P. Schulz; 12-08-2012 at 05:05 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco QSFP-100G-LR4-S 100GBASE-LR4 QSFP28, 1310nm, 10km, LC, SMF
$335.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Silicom (PE210G2SPI9A-XR) 10Gb Dual Port SFP+ PCIe Ethernet Adapter Low Profile
$19.99
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.80