.
I use the measure count to define the frequency of wifi disconnect/reconnects.
count is defined as an alias in my /etc/profile, as follows:
In practice, it works this way:Code:alias count="date '+%h %e %H:%M:%S'; less /var/log/syslog > text; less text | fgrep restart; less text | fgrep -c disconnecting"
knoppix@Microknoppix:~$ count
Jan 17 19:18:36
Jan 17 14:25:56 Microknoppix syslogd 1.5.0#6.2: restart.
30
Given these three lines I deduce I have had 30 disconnect/reconnects in the current session
which began at about 14:26. Doing the subtraction that seems to be about 292/30 or once in
9.7 minutes on average. I know the reconnect time is usually quite small, on the order
of two seconds, usually. I'm currently using g-mode on either router since this gives a
much better result with this measure of performance. my n-mode results are on the order
of less than a minute between disconnects, using this same measure. I conclude my g-mode is
preferable to my n-mode as things stand right now.
This approach requires /var/log/syslog which, using Knoppix7, may be partially observed with
control-alt-F12, but I don't know how to manipulate it as above without providing the actual
log. I do this by adding the following entry to /etc/syslog-knoppix.conf
just below the existing tty12 statement:
Use two tabs to provide the space between none and /var above.Code:*.*;auth,authpriv.none /var/log/syslog
This log is re-established at boot. So, the accumulation of this record is of no consequence
in using a LiveUSB which is never left on-line overnight or when not in use for any significant
time. Needless to say, if you don't reboot often as I do, you may want to consider how much
space is consumed by contiuously recording syslog.
Juniper EX4600-40F-AFI 24 SFP+/SFP Ports 4 QSFP+ Ports Dual AC Switch
$1300.00
Juniper MX204 +JUNOS and Dual Power Supply + Rack Mount-LIFETIME WARRANTY
$8395.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX2200-C-12P-2G 12 Port Gigabit PoE 2 T/SFP 1G Network Switch
$129.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper MX204 +JUNOS X2 AC Dual Power Supply JN204/MX204 4x40GbE Or 4x100GB
$6999.99
JUNIPER EX4550-32F-AFO 32-PORT ETHERNET SWITCH 2x POWER SUPPLY - TESTED
$299.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$41.43