.
I use the measure count to define the frequency of wifi disconnect/reconnects.
count is defined as an alias in my /etc/profile, as follows:
In practice, it works this way:Code:alias count="date '+%h %e %H:%M:%S'; less /var/log/syslog > text; less text | fgrep restart; less text | fgrep -c disconnecting"
knoppix@Microknoppix:~$ count
Jan 17 19:18:36
Jan 17 14:25:56 Microknoppix syslogd 1.5.0#6.2: restart.
30
Given these three lines I deduce I have had 30 disconnect/reconnects in the current session
which began at about 14:26. Doing the subtraction that seems to be about 292/30 or once in
9.7 minutes on average. I know the reconnect time is usually quite small, on the order
of two seconds, usually. I'm currently using g-mode on either router since this gives a
much better result with this measure of performance. my n-mode results are on the order
of less than a minute between disconnects, using this same measure. I conclude my g-mode is
preferable to my n-mode as things stand right now.
This approach requires /var/log/syslog which, using Knoppix7, may be partially observed with
control-alt-F12, but I don't know how to manipulate it as above without providing the actual
log. I do this by adding the following entry to /etc/syslog-knoppix.conf
just below the existing tty12 statement:
Use two tabs to provide the space between none and /var above.Code:*.*;auth,authpriv.none /var/log/syslog
This log is re-established at boot. So, the accumulation of this record is of no consequence
in using a LiveUSB which is never left on-line overnight or when not in use for any significant
time. Needless to say, if you don't reboot often as I do, you may want to consider how much
space is consumed by contiuously recording syslog.
EX4600-40F-AFI-T Juniper EX4600 24x SFP+ 4x QSFP+ Switch W/ 2x PWS 5x Fan Module
$1449.00
Juniper Networks Net Screen 5400 Security System NS-5400-CHA-B W/ 3x PWS 1x FAN
$1900.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.07
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
JUNIPER EX4550-32F-AFO 32-PORT ETHERNET SWITCH 2x POWER SUPPLY - TESTED
$299.99
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00