Hi all, I often set up routers and other devices that start off with default IP addresses that aren't in the "normal" range of private addresses. For example, a Linksys WPG54G device has the default fixed address of 192.168.1.200, but my network has addresses on 192.168.0.* range with DHCP. So how to access the web configuration when you're on a "different" network? Easy peasy. Just launch a terminal, and type "sudo ifconfig 192.168.1.1 up" to assign yourself a address in the 192.168.1.* range. Then you should be able to "ping 192.168.1.200" and get a response. Now you can launch a web browser and do the web configuration on the router or other device. When you want to go back to your normal DHCP, just type "sudo ifconfig down" and wait until the icon on the notification area says "network disconnected", then "sudo ifconfig up" and you will get your DHCP assigned ip address back.
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
MITS ALTAIR 8800 B Original Vintage Microcomputer
$5250.00
MITS ALTAIR 8800 Vintage Computer w/ Keyboard, Floppy, boards - Buy It Now
$9275.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Cromemco Assembler / ROS Paper Tape - 1977 Altair IMSAI
$79.99
Cromemco Z-80 Monitor v1.0 Paper Tape - 1976 Altair IMSAI
$79.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00