Hi all, I often set up routers and other devices that start off with default IP addresses that aren't in the "normal" range of private addresses. For example, a Linksys WPG54G device has the default fixed address of 192.168.1.200, but my network has addresses on 192.168.0.* range with DHCP. So how to access the web configuration when you're on a "different" network? Easy peasy. Just launch a terminal, and type "sudo ifconfig 192.168.1.1 up" to assign yourself a address in the 192.168.1.* range. Then you should be able to "ping 192.168.1.200" and get a response. Now you can launch a web browser and do the web configuration on the router or other device. When you want to go back to your normal DHCP, just type "sudo ifconfig down" and wait until the icon on the notification area says "network disconnected", then "sudo ifconfig up" and you will get your DHCP assigned ip address back.
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Cisco N9K-C9332C ACI Spine switch 32 ports 40/100G QSFP28 + 2p 10G SFP
$5550.00
Cisco Catalyst 3850 48 PoE+ 48-Port Gigabit Managed Switch WS-C3850-48F-E
$150.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Nexus N9K-C93180YC-EX 48-Port 1/10/25G SFP + 6 40G/100G QSFP28 Switch
$789.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst 3850 WS-C3850-48U-S 48-Port UPOE Gb Switch w/ NM-2-10G (BH)
$134.96
Cisco N5K-C5010P-BF 20-Port Nexus 5010 Series 10GbE Gigabit Ethernet Switch
$119.99