Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
Dell PowerEdge FC830 8-SFF 4*Xeon E5-4669v3 2.1GHz No HDD/RAM Blade Server Node
$179.99
Dell PowerEdge FX2S 4 Slot Blade Chassis - CMC, 2x 2400W PSU
$299.00
HP ProLiant BL460c Gen9 Blade 2x E5-2699v3 2.3GHz =36 Cores 128GB P246 650FLB
$273.00
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$44.99
Dell PowerEdge M620 Blade Server
$39.99
Dell PowerEdge M620 CTO Blade Server (for M1000e or VRTX) 32GB(4x8GB RAM) No HDD
$72.16
Dell VRTX 25 Bay SFF with 4 x M630 With (2) E5-2690 V4's 32GB Ram
$999.99
HP ProLiant BL460c Gen9 Blade 2x E5-2660v4 2.0GHz =28 Cores 128GB P246 650FLB
$219.00
DELL PowerEdge M630 Blade 2x E5-2680v4 2.4GHz =28 Cores 128GB H330 2x10Gb X520
$227.00