Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.24
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
JUNIPER EX4200-24PX 24-Port Gigabit PoE+ Managed Ethernet Network Switch
$49.95
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch with RACK EARS, RESET
$46.99
Juniper EX2300-48P 48-Port Gigabit Ethernet Switch PoE+ 4x SFP+ Power Cable
$104.40
Juniper Networks EX2300-48P 48-Port PoE+ Network Gigabit Ethernet Switch *READ*
$129.99
JUNIPER SRX340 SERVICE GATEWAY APPLIANCE Tested/Working #73
$111.99
Juniper Networks EX3300 EX3300-48P PoE+ 48-Port 4x SFP Gigabyte Ethernet Switch
$59.99