Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$229.00
Apple IIc Analog Board NOS - 661-0265
$74.00
Apple Macintosh SE/30 M5119 Computer 8MB RAM Recapped Working *See Description*
$475.00
IBM Modem Saver Phone Line Tester
$7.99
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
ACASIS PCIE Capture Card HDMI 1.4 1080P60HZ PCIE 2.0 X4 20Gbps for Video Capture
$248.99
Sony Trinitron CPD-1304 9 PIN Analog Vintage CRT Monitor - Great for Retro PC
$475.30