Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Silicom (PE210G2SPI9A-XR) 10Gb Dual Port SFP+ PCIe Ethernet Adapter Low Profile
$19.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco GLC-TE 1000BASE-T SFP, 100m, Copper, RJ45
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00