dsl network enabled but internet not working

[Lenny86]

Hello to all,I am using knoppix 7.2 , I seem to have some problems with accessing the internet. I have a dsl connection (dynamic ip) type and I enable it but the internet does not work , for example I can`t use the 'sudo apt-get' commands because it obviesly gives connection error but i can ping myself, altough I cant ping any other sites also note that there is no error in the network connection it seems to be connected and ok here are some command outputs:

knoppix@Microknoppix:/etc$ ping localhost
PING Microknoppix (127.0.0.1) 56(84) bytes of data.
64 bytes from Microknoppix (127.0.0.1): icmp_req=1 ttl=64 time=0.040 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=2 ttl=64 time=0.041 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=3 ttl=64 time=0.054 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=4 ttl=64 time=0.043 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=5 ttl=64 time=0.041 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=6 ttl=64 time=0.043 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=7 ttl=64 time=0.042 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=8 ttl=64 time=0.040 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=9 ttl=64 time=0.041 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=10 ttl=64 time=0.043 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=11 ttl=64 time=0.041 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=12 ttl=64 time=0.042 ms
64 bytes from Microknoppix (127.0.0.1): icmp_req=13 ttl=64 time=0.030 ms

knoppix@Microknoppix:/etc$ ping google.com
ping: unknown host google.com
knoppix@Microknoppix:/etc$ ping www.google.com
ping: unknown host www.google.com

knoppix@Microknoppix:/etc$ ifconfig
eth0 Link encap:Ethernet HWaddr 50:e5:49:d7:5e:e9
inet6 addr: fe80::52e5:49ff:fed7:5ee9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:301 errors:0 dropped:0 overruns:0 frame:0
TX packets:322 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:34475 (33.6 KiB) TX bytes:34144 (33.3 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:406 errors:0 dropped:0 overruns:0 frame:0
TX packets:406 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:30808 (30.0 KiB) TX bytes:30808 (30.0 KiB)

ppp0 Link encap:Point-to-Point Protocol
inet addr:79.119.163.222 P-t-P:10.0.0.1 Mask:255.255.255.255
inet6 addr: fe80::4f77:a3de/10 Scope:Link
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:227 errors:0 dropped:0 overruns:0 frame:0
TX packets:223 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:24738 (24.1 KiB) TX bytes:21334 (20.8 KiB)

resolv.conf is empty

resolv.conf.tmp:

# Generated by NetworkManager
nameserver 193.231.252.1
nameserver 213.154.124.1

resolv.conf.pppd-backup.ppp0:

# Generated by NetworkManager
nameserver 193.231.252.1
nameserver 213.154.124.1

My internet connection worked well until now and work right now under windows xp, knoppix is on usb stick.

[Lenny86]

It`s been aalmost a week , can anybody provide an answer to my problem???

[Werner P. Schulz]

Please tell us, which file do you have in '/etc/NetworkManager/system-connections' and what is the content of it? (You must be root to read it.)

[Lenny86]

[pppoe]
username='my username'
password='and the password'

[connection]
id=RDS
uuid=51867b63-ff06-4459-9a85-11fc3d816811
type=pppoe
autoconnect=false

[ppp]
lcp-echo-failure=5
lcp-echo-interval=30

[802-3-ethernet]
duplex=full

[ipv4]
method=auto

Everything coincides with what I`ve set up , the username and the password are ok too.
This exact connection worked before but suddenly something happend.
Could some ports be restricting packets???