I wanted to start an ubuntu virtual machine as follows in Knoppix 7.2.0DVD (booted with 'fromhd'):
root# qemu-system-x86_64 -cdrom ubuntu-12.04.3-dvd-amd64.iso
The iso image was read OK, with the ubuntu boot screen appearing in the vga display of the emulator. However the booting failed with the following message:
[ 29.044201] BUG: soft lockup - CPU#0 stuck for 23s! [swapper/0:1]
[ 53.044186] BUG: soft lockup - CPU#0 stuck for 22s! [swapper/0:1]
[ 89.044214] BUG: soft lockup - CPU#0 stuck for 23s! [swapper/0:1]
When the iso image is burned to a DVD, the ubuntu system boots up without a problem from the disk. And "qemu-system-x86_64" starts a Knoppix VM from iso without problems. So it appears that the ubuntu iso and the qemu behaves as expected individually.
Although this problem may reside well outside the domain of Knoppix per se, I hope I may receive advice on where to go from here. Thanks in advance for any help.
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$314.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Intel E25GSFP28SR 10G/25GBASE-SR SFP28 SR 850nm LC 300m FC Transceiver
$95.00
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Lot of 10 SFP-GB-GE-T Copper RJ45 10/100/1000Base-T 100m Transceiver Modules
$29.94
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99