-
Junior Member
registered user
knppix as a winxp ics client
I am trying knoppix 3.2 cd on my laptop, and I am using my winxp box's ICS (the ICS worked fine with my laptop running winxp as a ICS client). When I ran netcardconfig on the laptop, a message promted after a few seconds:
Sending DHCP broadcast from device eth0 Operation failed.
Failed.
I then tried to connect the laptop directly to my cable modem. This time, the network is automaticly setup and I can access the internet. So, the problem seems to be between winxp ICS and knoppix. I did some digging in the previous posts and but could not find a solution. Could someone please advise on how to diagnose and fix?
Thanks much.
Similar Threads
-
By Matrox462 in forum Networking
Replies: 1
Last Post: 01-07-2005, 03:00 AM
-
By lor in forum Hdd Install / Debian / Apt
Replies: 0
Last Post: 10-25-2004, 05:24 PM
-
Replies: 0
Last Post: 03-11-2004, 07:55 AM
-
By BigM in forum Networking
Replies: 0
Last Post: 03-10-2004, 09:34 AM
-
By cyKeMatica in forum Networking
Replies: 3
Last Post: 02-20-2004, 04:08 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco NC55-MPA-12T-S Port Adapter NCS 5500 Modular Chassis CISCO EXCESS UNIT
$3900.00
Cisco 1100 Terminal - gateway - rack-mountable C1100TGX-1N24P32A
$1349.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco CBS350-24FP-4G 28 Port PoE Managed Ethernet Switch
$319.99
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Lot of 4 Cisco QSFP-40G-SR-BD 10-2945-02 Transceiver Modules Hologram
$47.99
Cisco C9200 48-Port Gigabit Network Switch With Ears P/N: C9200-48T-E Dual Power
$799.97
New Cisco C9200-NM-4X Catalyst 9200 Series Network Module 4 X 10GE *MINT*
$429.97