You can also use right mouse click on the device within the left side of PCManFM.
Hi all,
It would always bother me to just unplug my flash drives under linux/knoppix without cleanly unmounting them. Under windows you have the "Safely remove devices" on the taskbar. So I did a bit of searching and if you use the command line:
udisks --detach /dev/sdg
where /dev/sdg is the location of the flash drive, it will be detached and powered down (assuming you haven't still got it mounted.)
You can also use right mouse click on the device within the left side of PCManFM.
Because I don't fully trust any file managers for such tasks, I normally use the command line, with mount/umount, and sync. That's of course old-fashioned and awkward, but it works safely. In particular, running sync can give some unexpected results when you just thought everything was written to disk already. It wasn't.
If you try to unmount an USB device within PCManFM as I described you'll get this message, if there are any jobs not finished.
Remount.png
Cisco SFP-10G-T-S 10GBASE-T SFP+, 30m@Cat6a/Cat7, Copper, RJ45
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Cisco GLC-TE 1000BASE-T SFP, 100m, Copper, RJ45
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95