Do not run wireshark as user "root"!
Read some documentations about wireshark. Your problem isn't a Knoppix problem.
When I launch wireshark(from k-menu..run, or from the command line) it loads but doesn't list interfaces unless I do sudo wireshark or I suppose if I do su then wireshark. That's fine.
But sudo wireshark or su<ENTER>wireshark<ENTER> isn't working.
It worked yesterday but now when I try, I get this error
knoppix@Microknoppix:~$ su root
root@Microknoppix:/home/knoppix# wireshark
No protocol specified
(wireshark:4986): Gtk-WARNING **: cannot open display: :0
root@Microknoppix:/home/knoppix# su knoppix
knoppix@Microknoppix:~$ sudo wireshark
No protocol specified
(wireshark:503: Gtk-WARNING **: cannot open display: :0
knoppix@Microknoppix:~$
Do not run wireshark as user "root"!
Read some documentations about wireshark. Your problem isn't a Knoppix problem.
Thanks. I got it to work since some days back. For the record it was most likely this solution that I used
http://ask.wireshark.org/questions/7...erfaces-listed
$ sudo apt-get install wireshark
$ sudo dpkg-reconfigure wireshark-common
$ sudo usermod -a -G wireshark $USER
$ sudo reboot
Cisco GLC-FE-100LX 100BASE-LX SFP Transceiver Module
$15.59
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 100m LC MMF
$68.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Nvida Mellanox MC3208411-T 1000GBASE-T SFP-TX 100m Optical 1GbE Base-T RJ45 New
$34.95