Hi folks
Summmary:
1. Is there a way to mount my spare partition /dev/sda7 on my chosen mount point
/home/knoppix/videos, instead of on /media/sda7, which is what /etc/fstab
specifies, ie
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
2. I've got Knoppix live distro installed on hard disc, distro 7.0.2, kernel
release 3.3.7.
Thanks very much. John.
Full Details:
3. I'd like to mount my spare /dev/sda7 resiserfs partition on say
/home/knoppix/videos, an empty directory that I've created.
4. To do this, I was going to add the following entry in /etc/fstab:
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
Note, I would use the "auto" option in column 4, to make the mount occur
automatically at boot time.
5. The present /etc/fstab (before adding anything to it) is:
# DEFAULT BASE FSTAB, UNCONFIGURED
proc /proc proc noauto 0 0
sysfs /sys sysfs noauto 0 0
/dev/sda6 / reiserfs relatime 0 0
/dev/sda5 none swap defaults 0 0
# Added by KNOPPIX
noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sda3 /media/sda3 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sr0 /media/sr0 auto noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sda2 /media/sda2 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
# Added by KNOPPIX
/dev/sda1 /media/sda1 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
6. As a test, I commented out the following lines in /etc/fstab:
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
But I discovered that the system ADDS THESE LINES AGAIN to /etc/fstab. So I'm
concerned that if I add my new line, ie
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
that even if I comment-out the following 2 lines, ie
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
that the system will re-add them. This would result in a CLASH between the 2
lines as follows:
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
(The reason I want to comment-out the line
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
rather than remove it, is so that I can see what USED TO BE in /etc/fstab.)
MAIN QUESTION:
Is there a way to stop Knoppix re-adding the entry
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
so that just my new entry
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
is used.
7. If don't alter /etc/fstab, I can MANUALLY mount /dev/sda7 on my mount point
thus
$ sudo mount -t reiserfs /dev/sda7 /home/knoppix/videos
But this is not a sensible state of affairs because /etc/fstab still contains
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
which is a contradiction.
Last edited by winger9; 06-09-2014 at 04:45 PM. Reason: typo
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
QLOGIC 32G 850nm SFP+ Module FTLF8532P4BCV-QL
$44.99
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00