Hi folks
Summmary:
1. Is there a way to mount my spare partition /dev/sda7 on my chosen mount point
/home/knoppix/videos, instead of on /media/sda7, which is what /etc/fstab
specifies, ie
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
2. I've got Knoppix live distro installed on hard disc, distro 7.0.2, kernel
release 3.3.7.
Thanks very much. John.
Full Details:
3. I'd like to mount my spare /dev/sda7 resiserfs partition on say
/home/knoppix/videos, an empty directory that I've created.
4. To do this, I was going to add the following entry in /etc/fstab:
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
Note, I would use the "auto" option in column 4, to make the mount occur
automatically at boot time.
5. The present /etc/fstab (before adding anything to it) is:
# DEFAULT BASE FSTAB, UNCONFIGURED
proc /proc proc noauto 0 0
sysfs /sys sysfs noauto 0 0
/dev/sda6 / reiserfs relatime 0 0
/dev/sda5 none swap defaults 0 0
# Added by KNOPPIX
noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sda3 /media/sda3 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sr0 /media/sr0 auto noauto,users,exec 0 0
# Added by KNOPPIX
/dev/sda2 /media/sda2 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
# Added by KNOPPIX
/dev/sda1 /media/sda1 ntfs noauto,users,exec,umask=000,uid=knoppix,gid=knoppi x 0
0
6. As a test, I commented out the following lines in /etc/fstab:
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
But I discovered that the system ADDS THESE LINES AGAIN to /etc/fstab. So I'm
concerned that if I add my new line, ie
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
that even if I comment-out the following 2 lines, ie
# Added by KNOPPIX
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
that the system will re-add them. This would result in a CLASH between the 2
lines as follows:
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
(The reason I want to comment-out the line
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
rather than remove it, is so that I can see what USED TO BE in /etc/fstab.)
MAIN QUESTION:
Is there a way to stop Knoppix re-adding the entry
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
so that just my new entry
/dev/sda7 /home/knoppix/videos reiserfs auto,users,exec 0 0
is used.
7. If don't alter /etc/fstab, I can MANUALLY mount /dev/sda7 on my mount point
thus
$ sudo mount -t reiserfs /dev/sda7 /home/knoppix/videos
But this is not a sensible state of affairs because /etc/fstab still contains
/dev/sda7 /media/sda7 reiserfs noauto,users,exec 0 0
which is a contradiction.
Last edited by winger9; 06-09-2014 at 04:45 PM. Reason: typo
Cisco GLC-SX-MM 1000Base SX SFP Transceiver Module 30-1301-02
$5.99
Cisco 10-2456-03 Genuine Cisco SFP-10G-LRM V03 10GBASE-LRM SFP+Transceiver
$24.99
Dell EMC FTLF8532P4BNV-E5 019-078-057 32G SFP28 Fiber Channel 850nm Transceiver
$57.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
F5 Networks 10GB OPT-0016-00 F5-UPG-SFP+-R 10GBASE/SR SFP Transceiver
$4.00
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00