I have a laptop that I got from work, and installed Knoppix on a thumbdrive so I could use it for personal use. When I installed Knoppix, the laptop was a Dell and I installed Knoppix 6.4, everything worked fine out of the box. I got a new laptop, this time an HP, but everything still worked fine except for a few minor sound issues. I installed it on a 16 Gig thumbdrive, and surprisingly filled the Thumb drive up. So I got a new 64 gig one and have installed knoppix 7.2 on it. It works great except when connected to the docking station, which has 2 - 19" monitors, 1 connected with DVI and one with the analog connector. Linux boots fine, but when it tries to initiate the gui, it fails saying to try some cheat codes. I've tried several, but it haven't gotten anything to work. The 6.4 version works fine with the docking station. Can anyone give me any suggestions on getting this to work.
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
$22.50
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00