I have a laptop that I got from work, and installed Knoppix on a thumbdrive so I could use it for personal use. When I installed Knoppix, the laptop was a Dell and I installed Knoppix 6.4, everything worked fine out of the box. I got a new laptop, this time an HP, but everything still worked fine except for a few minor sound issues. I installed it on a 16 Gig thumbdrive, and surprisingly filled the Thumb drive up. So I got a new 64 gig one and have installed knoppix 7.2 on it. It works great except when connected to the docking station, which has 2 - 19" monitors, 1 connected with DVI and one with the analog connector. Linux boots fine, but when it tries to initiate the gui, it fails saying to try some cheat codes. I've tried several, but it haven't gotten anything to work. The 6.4 version works fine with the docking station. Can anyone give me any suggestions on getting this to work.
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$29.91
JUNIPER ELECTRONICS NFX250-ATT-LS1
$250.00
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper Networks SRX345 Gateway Appliance
$195.00
Juniper 48-Port PoE GbE Network Switch w/ 4-Port 10GB SFP+ Module EX4300-48P
$179.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$140.00
Juniper Networks EX2200-C-12P-2G Gigabit Ethernet Managed Switch w/ Rack Mounts
$74.99
Juniper EX2200-C-12T-2G Fanless 12-port Ethernet Switch with 2 SFP
$75.77
Juniper Networks SRX220 8-Port Gigabit Services Gateway Security Appliance
$45.00