If you want to start with Adriane in a HD installation rename '/etc/inittab' to '/etc/inittab_orig' and copy '/etc/inittab.adriane' to '/etc/inittab'.
Hello!
I've installed Knoppix to hard drive using 0wn. I want to set it up to boot in Adriane mode, and tweak the menu for my father.
I tried to add "adriane" at Grub boot line, but it keeps booting in graphical mode.
I've downloaded the DVD version 7.4.2 and I used Unetbootin to put it in a pendrive (USB flash drive). I've found that the DVD boot process is different from the hdd install boot process. The DVD's seems to change /etc/inittab, /etc/sudoers and /etc/PolicyKit/PolicyKit.conf from some init script. But I don't know how to set this up for the hdd.
So, what are my options to change the boot process in the hdd install? Keep in mind, that I would like to change the default Adriane menu, and I'm not planning to remaster a Knoppix/Adriane DVD
Finally: Thank you, Klaus, for mastering this distro! : - D
Thanks in advance for your time and your advice,
Regards,
-- Knoforus
If you want to start with Adriane in a HD installation rename '/etc/inittab' to '/etc/inittab_orig' and copy '/etc/inittab.adriane' to '/etc/inittab'.
Thanks Werner! It worked as you said. ^_^
Regards,
-- Knoforus
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 88-2SIO Reproduction Board
$35.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair SD PROM 100 2708 2716 2732 EPROM Programmer board Card S100 PCB #AX49
$249.00