Hi!
It's a common problem, not a lot of people get this right. When I boot with lang=ru cheatcode, /etc/init.d/knoppix-autoconfig automatically selects xkeyboard=ru, too. The problem is that to get any work done I still need to go to keyboard layout settings, add 'us' keyboard and select some switchng hotkey (it's impossible to type commands or URIs with 'ru' layout, you'll get ыуечлиьфз -щзешщт пкзЖсекд_ыршае_ещппду гыбкг and реезЖ..лтщззшчютуе. instead). It's not a grave problem in Knoppix (not only I can add xkeyboard=us to boot parameters, there is even a GUI to setup layouts), but it can be solved completely in different ways:
1) Add another cheatcode which would set XKBOPTIONS in /etc/default/keyboard, so it would be possible to boot like this: knoppix lang=ru xkeyboard=us,ru xkbopts=grp:ctrl_shift_toggle
2) Copy the logic from, for example, d-i (https://sources.debian.net/src/conso...n.config/#L487): they first set the layout[s] based on the locale, adding 'us' if needed, then add -option grp:alt_shift_toggle,grp_led:scroll if there is more than one layout (also, lv3:ralt_switch if the layout is single, but non-US).
Best regards,
Ivan
Cisco SFP-10G-T-S 10GBASE-T SFP+, 30m@Cat6a/Cat7, Copper, RJ45
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Cisco GLC-TE 1000BASE-T SFP, 100m, Copper, RJ45
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95