-
Dual PIII boots and runs from 7.2.0 CD but after HD Inst hangs on boot
7.2.0 booted and ran fine from the CD.
I did the HD install, and there were no problems.
It says to reboot, so I try to reboot, it starts booting, the Grub screen comes up, has KNOPPIX option, but it hangs after "Booting the Kernel".
I tried adding debug to the boot command, but it says that's invalid...
Any ideas how to diagnose?
PS: the drives are SCSI, but I figured if it can see them and format when booted from CD I would think it can see them ok
thanks
Last edited by thriftee; 01-01-2016 at 10:52 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Juniper EX4300-24T Layer 3 24 Ports Manageable Ethernet Switch 1 Year Warranty
$139.00
Juniper EX3300-48T-BF 48 Port 4 X Expansion Slots Layer 3 Switch 1 Year Warranty
$235.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper Networks EX2300-24P 24 Port Gigabit PoE 4 SFP 1/10G Network Switch
$115.00
EX2300-24P Juniper 24-port 10/100/1000BASE-T PoE+ 4 x 1/10GbE SFP/SFP+ UNCLAIMED
$450.00
Juniper Networks EX3400-48P 48x Gigabit PoE+ RJ45 2x 40Gb/s QSFP+ Switch
$166.24
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$41.28
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00