-
Dual PIII boots and runs from 7.2.0 CD but after HD Inst hangs on boot
7.2.0 booted and ran fine from the CD.
I did the HD install, and there were no problems.
It says to reboot, so I try to reboot, it starts booting, the Grub screen comes up, has KNOPPIX option, but it hangs after "Booting the Kernel".
I tried adding debug to the boot command, but it says that's invalid...
Any ideas how to diagnose?
PS: the drives are SCSI, but I figured if it can see them and format when booted from CD I would think it can see them ok
thanks
Last edited by thriftee; 01-01-2016 at 10:52 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 88-2SIO S-100 Reproduction Board
$35.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
Build S-100 Bus Computer Peripherals Altair 8800 IMSAI 8080 Disk I/O Graphics
$59.99
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99