I have been a long term user of Knoppix and generally been happy with it 'out the box'
But I am at a loss on how to get Virtualbox working on Knoppix 7.6 so have been stuck using 7.0 which seems to be the last release with a working version of VirtualBox.
I have spend hours googling the problem and think that I am now pretty close - but no cigar.
After a reboot I get the familiar driver missmatch messages- but this is wha I have done on a clean install of KNoppix 7.6 32 bit.
Add the following line to /etc/apt/sources.list:
deb http://download.virtualbox.org/virtualbox/debian wheezy contrib (stretch did not seem to work)
sudo apt-get remove virtualbox*
wget -q https://www.virtualbox.org/download/..._vbox_2016.asc -O- | sudo apt-key add -
wget -q https://www.virtualbox.org/download/oracle_vbox.asc -O- | sudo apt-key add -
sudo apt-get update
sudo apt-get install virtualbox-5.1
sudo apt-get install dkms
And I get this error message when I try and run an environment:
RTR3InitEx failed with rc=-1912 (rc=-1912)
The VirtualBox kernel modules do not match this version of VirtualBox. The installation of VirtualBox was apparently not successful. Executing
'/sbin/vboxconfig'
may correct this. Make sure that you do not mix the OSE version and the PUEL version of VirtualBox.
where: supR3HardenedMainInitRuntime what: 4 VERR_VM_DRIVER_VERSION_MISMATCH (-1912) - The installed support driver doesn't match the version of the user.
If I run this command its a little hit or miss if it works - but I end up back in the same state following a reboot.
Does anyone have a working set of installation instructions?
Regards
John
Cisco QSFP-100G-LR4-S 100GBASE-LR4 QSFP28, 1310nm, 10km, LC, SMF
$335.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Silicom (PE210G2SPI9A-XR) 10Gb Dual Port SFP+ PCIe Ethernet Adapter Low Profile
$19.99
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.80