Why not read- and writable? I suppose you are using a "poor man's install.
First I boot knoppix as:
then I seeknoppix64 init 2 no3d fromhd="/dev/sdc5"
$ mount | grep mnt-system
/dev/sdc5 on /mnt-system type ext4 (rw,relatime,block_validity,delalloc,barrier,user_ xattr,acl)
$ blkid | grep sdc5
/dev/sdc5: LABEL="KNPX771" UUID="54e317fe-73cf-4b1c-8b1f-dfc9b708b68a" TYPE="ext2" PARTUUID="591ef660-03"
Why not read- and writable? I suppose you are using a "poor man's install.
OK, I (most probably wrongly) thought that partition used for a "poor man's install" would be read-only anyway
Say, you would like to define the regular user directory on the starting command prompt and you don't want anything to be ever written there
In fact, you would run knoppix without a hard drive at all and set up a user account after it started in case you would like to save anything. I would say a few files (access control + security) would be altered, just a few ... but the rest should be read-only
How do you do that?
Last edited by Albretch; 12-19-2016 at 08:03 PM.
In this case I wouldn't use a Live Linux as Knoppix with all his limitations. I would prefer for example Debian.
HITACHI HUS724040ALA640 4TB 7200RPM 64MB SATA 6.0Gb/s 3.5" HARD DRIVE ZERO HOURS
$52.00
Western Digital 4TB Internal 7.2KRPM 3.5" (WD4000FYYZ) SATA Hard Drive ZERO HOUR
$69.99
Seagate ST1000VM002 1TB 64MB SATA6Gb/s 3.5" (Low Power) Hard Drive -PC, CCTV DVR
$24.99
Seagate ST8000NM0055 8TB 7200RPM 256MB SATA 6.0 Gb/s 3.5" Enterprise Hard Drive
$34.50
HGST Ultrastar DC HC520 12TB SATA 6Gb 256MB 3.5" Enterprise HDD- HUH721212ALE601
$74.99
CISCO A03-D1TBSATA 1TB 7.2K 6G 2.5INCH SATA HDD
$9.00
Seagate ST12000NM0127 12TB SATA 6Gb/s 256MB 7200RPM 3.5" Enterprise Hard Drive
$99.99
WD Ultrastar DC HC530 14TB SATA 6G 3.5" 7200RPM Enterprise HDD - WUH721414ALE604
$110.00
Seagate ST8000NM0055 8TB 7200RPM 256MB SATA 6.0 Gb/s 3.5" Enterprise Hard Drive
$34.50
Western Digital Gold Enterprise 4TB,7200 RPM Internal Hard Disk Drive WD4002FYYZ
$39.95