Why not read- and writable? I suppose you are using a "poor man's install.
First I boot knoppix as:
then I seeknoppix64 init 2 no3d fromhd="/dev/sdc5"
$ mount | grep mnt-system
/dev/sdc5 on /mnt-system type ext4 (rw,relatime,block_validity,delalloc,barrier,user_ xattr,acl)
$ blkid | grep sdc5
/dev/sdc5: LABEL="KNPX771" UUID="54e317fe-73cf-4b1c-8b1f-dfc9b708b68a" TYPE="ext2" PARTUUID="591ef660-03"
Why not read- and writable? I suppose you are using a "poor man's install.
OK, I (most probably wrongly) thought that partition used for a "poor man's install" would be read-only anyway
Say, you would like to define the regular user directory on the starting command prompt and you don't want anything to be ever written there
In fact, you would run knoppix without a hard drive at all and set up a user account after it started in case you would like to save anything. I would say a few files (access control + security) would be altered, just a few ... but the rest should be read-only
How do you do that?
Last edited by Albretch; 12-19-2016 at 08:03 PM.
In this case I wouldn't use a Live Linux as Knoppix with all his limitations. I would prefer for example Debian.
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00