Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco Systems Nexus 7700 10 Slot Chassis Fab 3 Mod | N77-C7710-FAB-3
$4999.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Nexus N9K-C93180YC-EX 48-Port 1/10/25G SFP + 6 40G/100G QSFP28 Switch
$789.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst 3850 WS-C3850-48U-S 48-Port UPOE Gb Switch w/ NM-2-10G (BH)
$134.96
Cisco N5K-C5010P-BF 20-Port Nexus 5010 Series 10GbE Gigabit Ethernet Switch
$119.99