Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Cisco WS-C3560-48PS-S 48-Port Managed Gigabit PoE Switch
$56.00
Cisco WS-C3650-48FD-S 48-Port Gigabit Managed Switch
$49.99
EtherWAN EX17242 Web-Smart 24-Port PoE Gigabit Ethernet Switch
$29.99
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98