Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$55.99
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco WS-C4500X-24X-IPB 4500-X 24P RJ45 10Gbps GE IP Base Switch 1 Year Warranty
$385.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco CBS350-24FP-4G 28 Port PoE Managed Ethernet Switch
$319.99
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99
UNCLAIMED Cisco Meraki MS120-24P-HW - 24Ports Ethernet PoE Switch Same Day Ship
$315.00