Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Vintage Commodore 64C Personal Computer w/Manuals, Box, Power Supply DUAL ROM
$250.00
$799.00
Commodore VIC-20 Computer (working condition)
$120.00
Vintage Commodore 64 Personal Computer System W/Original Box Untested Powers On
$124.95
commodore 1541 floppy disk drive
$45.00
COMMODORE 64 - DRIVE 1541 - MONITOR 1702 - Miniature
$19.00
COMMODORE 1541 FLOPPY DRIVE FOR C64 64C VIC-20 C16 PLUS/4 128 TESTED/WORKING L33
$99.99
Kung Fu Flash Commodore 64 Cartridge New Fully Assembled USA Seller C64 C128
$28.49
COMMODORE 1541 FLOPPY DRIVE FOR C64 64C VIC-20 C16 PLUS/4 128 TESTED/WORKING L35
$89.99
COMMODORE 1541 FLOPPY DRIVE FOR C64 64C VIC-20 C16 PLUS/4 128 TESTED/WORKING L34
$99.99